E-2 Herbicide For Roadways Right-of-Ways Industrial Sites Roadsides ( 2.5 Gals)

Description

** Not For Sale To: CALIFORNIA, NEW YORK
( due to regulations )
E-2 Herbicide - 2.5 Gallons
This herbicide contains three proven and strong herbicides in one already mixed formula - 2,4-D, Fluroxpyr, and Dicamba.
E-2 Herbicide will control over 240 broadleaf weeds that includes: Horsetail, Kochia, Field Bindweed and several hard to control types.
E-2 Herbicide can also be used for selective weed control and can also be tanked mixed. Great powerful control in pasture and rangeland as well as cleaning up emerged weeds on utility substations, highways, guardrails, and industrial areas.
Targets:
Black medic, Chickweed, Clover, Cocklebur, Dandelion, Knotweed, Oxalis, Kochia, Horsetail, Pigweed, Toadflax, Vetch and others
Read label for complete list
Use:
Right-of-Ways, Roadsides, Industrial Sites, Farmstead, Recreation areas, Pastures & Range-lands
Read label for complete list
Read label for complete application instructions.
Active Ingredients:
2,4-D, dimethylamine salt 39.53% , Dicamba 4.1% , Fluroxypyr 1-methylheptyl ester 5.9%
NON-CROP AREAS
Rights-of-way, roadsides, industrial sites, fence rows, non-irrigation ditch banks, recreational areas and similar non-crop are as:
For control of broadleaf weeds, mix at a rate of 2 to 5 pints of this product per acre in adequate water to thoroughly saturate all weeds with spray mixture. This may require a spray volume of 50 to 300 gallons of water per acre. Apply any time between the time when plants come into full leaf (spring) to when the plants begin to go dormant. Best results are obtained when weeds are young and actively growing. Do not cut weeds until herbicide has translocated throughout the plant causing root death. For small broadleaf weeds, use the lower rate. Heavy, dense stands require the higher rate with high water volume. For small (spot) applications with small tank sprayers, apply at the rate of 2-1/4 ounces of this product per gallon of water and spray to thoroughly wet all foliage.
For control of woody plants:
Apply to both stems and foliage any time from the time foliage is completely matured until the time plants start to go dormant. All leaves, stems and suckers must be completely wet to the ground line for effective control. Regrowth may be anticipated on the more resistant species. Add 4 to 5 pints of this product per acre in adequate water to thoroughly saturate all weeds with the spray mixture. This may require a spray volume of 200 to 600 gallons of water per acre depending upon the height and thickness of the brush. Mix thoroughly before spraying.
PASTURES, RANGELAND and GRASS (HAY, SILAGE)
For these uses, mix at a rate of 2 to 5 pints of this product per acre. Retreatment may be made as needed; however the maximum seasonal application rate is 2 pounds 2,4-D acid equivalent per acre per application. Minimum of 21 days between applications, limited to 2 applications per year. The preharvest interval (PHI) is 7 days (for cut forage for hay)
Best results will be obtained if this product is applied at the germinating stage of weeds. Under favorable conditions, this is usually 7 to 10 days after planting these grasses. Reduced control can be expected if weeds are allowed to reach 1” in height before application or if germination of weeds occurs 10 days after application. Do not use on bentgrass, susceptible grass pastures (such as carpetgrass, buffalograss, or St. Augustine grass), lespedeza, wild winter peas, vetch, clover, and alfalfa pastures as injury will occur.
When perennial weeds are reaching maturity, mowing and allowing some regrowth will enhance control. Difficult to control weeds and brush may require repeat applications. For pasture renovations, wait 3 weeks per quart (2 pints) of this product used per acre before interseeding or injury may occur. If grasses are grown for seed or for seed-down purposes, do not apply after grass reaches the joint stage.
No oral advice or written information given by American Pest supplies shall create a warranty.
American Pest Supplies is a seller of various products. American Pest Supplies does not warranty the safety or the effectiveness of any of the products listed on this website. Any warranty or guarantee of safety or purpose for any particular use lies solely with the manufacturer.
Pest Control Products always have a label attached and it is here by noted that for all purposes the label is the law and according to federal law the product label must be followed and that any pesticide product must be used according to the label directions.
Any advice or recommendations given by American Pest supplies or anyone representing American Pest Supplies will never be intended to take the place of the pesticide label.The pesticide label is the law and a legal document.  Always read and follow the label directions before using any pesticide product.
Some of the products sold by American Pest Supplies could require special licensing training or registration of the user in that users State, County, City, Etc. It is the sole responsibility of the purchaser and/or the end user to provide a license, permit, registration etc. If required by that purchasers local or state authorities.It is the sole responsibility of the user to verify that any products purchased are licensed for use in their State, County or City.
The customer assumes all responsibility for safe, proper and legal use of any products they purchase. The products we sell are intended for personal use only, in accordance with the customer's state laws and restrictions.
It is a violation of Federal law to use this product in a manner inconsistent with its labeling. The Label is The Law !
This product cannot be used for any purpose that it is not labeled for!